You could "polish" the grate a bit with your angle grinder. If it's tough now it will probably get worse with rust and ash building up.h2orescuemedic wrote: ↑May 12th, 2019, 5:08 pmits the grate that the charcoal sits on. If i was to build another one i would add about a 1/16 of an inch to the angle iron that it sits on, It needs just a little wiggle room to make a touch easier to pull out. Its a little tight on mine,
How hot does that high temp powder coat go up to? Have you had any issues since you put it on?h2orescuemedic wrote: ↑February 26th, 2019, 8:25 pmTapped up and ready for powder coat. They talked me into high temp gray, They was afraid the temp of the chimney would make the paint soft and it would discolor,